Connects USB to JTAG Ports for downloading FPGA Bit-File from host PC to program GW FPGA devices on PCB Board.

This ribbon cable allows you to extend all 30 pins on the 2x15 pin male connector to a 2x15 pin female connector.

USB cable 3.0 with USB 3.1 C-plug and USB 3.0 A-plug, transmission rate up to 50,000 Mbit/s

This assembly features a 2x16 keyed female pin connector for the DIN_USR connector, with 24 DIN signals (various colors) and 8 GND wires (black).

The 2X6 flywire features two VCCIO_USR wires (red), two GND wires (black), and eight signal wires (colored).

Ribbon Jumper Cable, 51 Position FFC Cable 0.012" (0.30mm) 6.00" (152.40mm), accessory for icoBoard

USB-A to USB-B micro cable 1,5 m

This kit is a handy accompaniment to your 12-pin Pmod.

This extender cable is perfect for locating your motor/gearboxes wherever you need. 10" in length (260±20 mm)

length of the cable 15,2 cm

Free up your Analog Discovery for other projects!

Extruding strip cable, solid tinned copper wire No. 28 AWG (0,09 mm2), pitch: 1,27 mm, grey

This kit is a handy accompaniment to your 6-pin Pmod.

This kit is a handy accompaniment to your 6-pin Pmod.

This kit is a handy accompaniment to your 6-pin Pmod.

VG64ac socket connector for DIN 41612 ribbon cable, mates with Trenz Electronic level conversion boards.

10 Jumper Cable, 20 cm length in 10 colors

50 Jumper Cable, 20 cm length in five colors

10 colours, Arbitrary divisible

1 pin MTE cable for all Digilent Boards

USB 2.0 compatible, length 2 meters

USB A to mini B Cable, 1,50 m length (5 feet)

Provides power to battery connection on a Digilent Board or access to any 2 signals that are tied to any 100mil spaced pins.

2 pin MTE cable for any Digilent board.

4 pin MTE cable for all Digilent boards

Provides the option to separate 6 signals using MTE connectors, 6-pin connectors are standard 100mil spaced 25mil square connectors

4 pin to 2x2-pin MTE cable for all Digilent boards

The JTAG-USB cable allows you to use your PC to connect to a JTAG scan chain or to access an SPI interface on a board equipped with the appropriate 6-pin header.

Pmod Crossover Cable Needed to Connect Old and New UART Interfaces

HDMI Cable - 1 Meter, 40" in length (Type A to Type A).

Infrared Proximity Sensor, ideal for use with PmodLS1.

Designed to connect a 12-pin Pmod to a 12-pin system board connector.

Designed for use with Digilent Peripheral Modules that have 2x6 pin connectors. Connects two 6-pin system board connectors to a 12-pin Pmod connector, or vice versa.

2 pin MTE cable for all Digilent Boards.

User-friendly configuration of Xilinx FPGAs and programming of Xilinx PROM and CPLD devices.

BASIC-S USB 2.0 micro cable